how to wire a 1972 vw type 2 camper/bus from the ignition switch to the fuse box

For those who are looking to restore the power of a 1972 VW Type 2 Camper Bus, wiring the ignition switch fuse box is an important part of the process. This guide will provide step-by-step instructions on how to wire the ignition switch fuse box safely and effectively.

For starters, it’s important to remember that all wiring should be done in accordance with local and national electrical codes. This is an especially important consideration for older vehicles like the 1972 VW Type 2 Camper Bus. Before beginning any wiring work, make sure you have the necessary tools and materials, including wire cutters, insulation tape, pliers, and a voltmeter.

Next, locate the ignition switch fuse box and disconnect it from the battery. Once this is done, you’ll need to remove the upper section of the fuse box and locate the terminals. These terminals will be labeled with numbers and colors, so it’s important to refer to your vehicle’s manual to ensure you’re connecting the right wires in the right places. Start by connecting the negative (black) terminal of the battery to the main chassis ground, then attach the positive (red) terminal of the battery to the positive terminal of the starter solenoid.

From there, connect the main power wire between the ignition switch and the starter solenoid, then connect the other wires to their respective terminals. Finally, test the circuit and make sure all of the connections are secure. If everything looks good, reconnect the fuse box to the battery and you’re finished!

Wiring the ignition switch fuse box of a 1972 VW Type 2 Camper Bus may seem daunting at first, but with a little patience and the right tools, it’s a relatively straightforward process. Just be sure to take your time, double check all of your connections, and follow local and national electrical codes. Good luck!

Steering Column Work